Half step forward

Block is back from the machine shop with a clean bill of health. Unfortunately, we had to put the head down. Since getting the block back its been painted and crank installed with ARP hardware. Used plastigage with standard size bearings to check clearances. Amazingly the crank has seen zero wear in the past thirty years. Clearance for all journals right around the min. spec.

Block treatment: thermal clean, magnaflux, decked, bore/hone.

Crank treatment: cleaned, magnaflux, measure, polish.

Cylinder head installed just for mockup.

MegaSquirt

No, its not Ron Jeremy's latest film. Its the DIY engine management from B&G.

Hit a couple glitches with assembly and testing, but all is up and running now. I feel very edumacated. Engine should be assembled in the next couple weeks. Then i need to do some wiring and set up the (aheemmmmmm) ford ignition system, and hopefully fire it up. Month maybe?

Blank MII V3.0 main board:

Partially assembled:

Completed board:

Completed board, relay board, and stimulator:

Megasquirt Megatune software, still not porn:

The engine is out getting all the machine work done. Lots of good stuff to come.